Of bore diameter exceeding 100 mm

Ball bearings of bore diameter exceeding 100 mm

NO PGA · STANDARD CUSTOMS PROCEDURE

HSN 8482 10 40 (ball bearings of bore diameter exceeding 100 mm) is not covered by a Bureau of Indian Standards Quality Control Order and carries no Partner Government Agency clearance requirement at the tariff-line level. Import follows the standard customs procedure: Importer-Exporter Code (IEC), bill of entry, commercial invoice, packing list. Other ball bearing tariff lines within Chapter 84 — particularly smaller-bore grades — may carry compliance under BIS Quality Control Orders applicable to bearings for specific end-use machinery sectors.

No partner government agency notification covers this tariff line.

A word of counsel

The principal importer risk at this tariff line is misclassification: bore diameter is the sole differentiator between this line and the sibling lines for smaller-bore ball bearings within heading 8482, and customs may re-measure or re-classify on examination. If re-classification moves the goods to a tariff line covered by a Quality Control Order, the consequence is detention pending BIS registration and retrospective compliance. Confirm bore diameter against the customs tariff specification before filing the bill of entry.

Need a regulatory steer on this product?

Speak to a regulatory counsel about your specific HSN, IS, and supplier situation.

Speak to an Expert

Frequently asked

Does HSN 8482 10 40 require any pre-import registration?

A valid Importer-Exporter Code is required for any commercial import; no product-specific registration applies to this tariff line.

What changes if the ball bearing has a bore diameter of 100 mm or less?

Smaller-bore ball bearings are classified under separate tariff lines within heading 8482 and may attract BIS Quality Control Order compliance depending on the applicable notification for that bore-diameter range.

Last verified against gazette notifications: 2026-05-16. Source: BIS / DGFT / Indian Customs CUSDATA.