Fittings for loose-leaf binders or files

Base metal fittings for loose-leaf binders or files

NO PGA · STANDARD CUSTOMS PROCEDURE

HSN 8305 10 00 (fittings for loose-leaf binders or files, of base metal) is not covered by a Bureau of Indian Standards Quality Control Order and carries no Partner Government Agency clearance requirement at the tariff-line level. Import follows the standard customs procedure: Importer-Exporter Code, bill of entry, commercial invoice, packing list. Other office articles of base metal within Chapter 83 — such as staples in strips, paper clips, or letter clips — are classified under sibling tariff lines and should be verified independently.

No partner government agency notification covers this tariff line.

A word of counsel

The principal importer risk at this tariff line is misclassification: ring mechanisms, lever-arch fittings, and similar binder hardware are product-specific, and customs examiners may re-classify to a sibling line within Chapter 83 if the product description is imprecise. Re-classification triggers retrospective compliance and potential detention pending resolution. Ensure the commercial invoice and packing list describe the fitting type, base metal composition, and intended use with sufficient specificity to sustain the declared classification.

Need a regulatory steer on this product?

Speak to a regulatory counsel about your specific HSN, IS, and supplier situation.

Speak to an Expert

Frequently asked

Does HSN 8305 10 00 require any pre-import registration?

A valid Importer-Exporter Code is required for any commercial import; no product-specific registration applies to this tariff line.

What changes if the goods are staples in strips or paper clips rather than binder fittings?

Staples in strips and paper clips are classified under separate tariff lines within Chapter 83 and must be verified independently for any applicable compliance requirements.

Last verified against gazette notifications: 2026-05-16. Source: BIS / DGFT / Indian Customs CUSDATA.