Titanium, wrought

Titanium, wrought (bars, rods, wire, plate, sheet)

NO PGA · STANDARD CUSTOMS PROCEDURE

HSN 8108 90 10 (Titanium, wrought) is not covered by a Bureau of Indian Standards Quality Control Order and carries no Partner Government Agency clearance requirement at the tariff-line level. Import follows the standard customs procedure: Importer-Exporter Code (IEC), bill of entry, commercial invoice, packing list. Other forms of titanium — including waste and scrap, or unwrought titanium — are classified under separate tariff lines within Chapter 81 that may carry distinct treatment.

No partner government agency notification covers this tariff line.

A word of counsel

The principal risk at this tariff line is misclassification: wrought titanium articles processed into identifiable end-use forms — tubes, flanges, fasteners — may be reclassified as articles of titanium elsewhere in Chapter 81, triggering retrospective duty recovery and detention pending re-examination. Importers should confirm that the product specification, form factor, and intended use all align with the wrought intermediate material category before filing the bill of entry.

Need a regulatory steer on this product?

Speak to a regulatory counsel about your specific HSN, IS, and supplier situation.

Speak to an Expert

Frequently asked

Does HSN 8108 90 10 require any pre-import registration?

A valid Importer-Exporter Code is required for any commercial import; no product-specific registration applies to this tariff line.

What changes if the titanium is in the form of waste, scrap, or a finished article?

Waste and scrap, unwrought forms, and finished articles of titanium are classified under separate tariff lines within Chapter 81 and may attract different duty rates or compliance requirements.

Last verified against gazette notifications: 2026-05-16. Source: BIS / DGFT / Indian Customs CUSDATA.