Other

Molybdenum bars, rods, profiles, plates, sheets, strip and foil

NO PGA · STANDARD CUSTOMS PROCEDURE

HSN 8102 95 90 (molybdenum bars, rods, profiles, plates, sheets, strip, and foil — other than sintered forms) is not covered by a Bureau of Indian Standards Quality Control Order and carries no Partner Government Agency clearance requirement at the tariff-line level. Import follows the standard customs procedure: Importer-Exporter Code, bill of entry, commercial invoice, packing list. Other molybdenum articles, including waste, scrap, or sintered bars and rods, are classified at distinct tariff lines within Chapter 81 that warrant independent compliance verification.

No partner government agency notification covers this tariff line.

A word of counsel

The principal risk at this tariff line is misclassification: molybdenum articles obtained simply by sintering fall under a separate subheading within Chapter 81, and an incorrect declaration may prompt customs re-classification on examination, triggering retrospective duty recovery and detention. Product form, manufacturing route, and intended use should be documented precisely in the bill of entry to support the declared tariff line and pre-empt any re-examination dispute.

Need a regulatory steer on this product?

Speak to a regulatory counsel about your specific HSN, IS, and supplier situation.

Speak to an Expert

Frequently asked

Does HSN 8102 95 90 require any pre-import registration?

A valid Importer-Exporter Code is required for any commercial import; no product-specific registration applies to this tariff line.

What changes if the molybdenum bars or rods are obtained simply by sintering?

Sintered bars and rods are classified under a distinct subheading within Chapter 81 and must be assessed independently for any applicable compliance obligations.

Last verified against gazette notifications: 2026-05-16. Source: BIS / DGFT / Indian Customs CUSDATA.