Electroplating anodes of nickel

NO PGA · STANDARD CUSTOMS PROCEDURE

HSN 7508 90 10 (Electroplating anodes of nickel) is not covered by a Bureau of Indian Standards Quality Control Order and carries no Partner Government Agency clearance requirement at the tariff-line level. Import follows the standard customs procedure: Importer-Exporter Code (IEC), bill of entry, commercial invoice, packing list. Other articles of nickel within Chapter 75 — particularly nickel powders, nickel tubes, or nickel alloy fabrications — may be classified under sibling tariff lines that attract distinct compliance obligations.

No partner government agency notification covers this tariff line.

A word of counsel

The principal importer risk at this tariff line is misclassification: nickel anodes intended for industrial electroplating are correctly classified here, but anodes supplied as part of a plating system, or nickel shapes that customs re-characterises as wrought nickel forms under Chapter 75, can trigger retrospective compliance and detention pending re-classification. Verify that the product specification — purity, dimensions, intended electroplating use — is documented in the commercial invoice in terms that match the tariff descriptor before shipment.

Need a regulatory steer on this product?

Speak to a regulatory counsel about your specific HSN, IS, and supplier situation.

Speak to an Expert

Frequently asked

Does HSN 7508 90 10 require any pre-import registration?

A valid Importer-Exporter Code is required for any commercial import; no product-specific registration applies to this tariff line.

What changes if the nickel article is a bar, rod, or other wrought form rather than an electroplating anode?

Wrought nickel bars, rods, and profiles are classified under different tariff lines within Chapter 75 and may attract distinct compliance or duty treatment on customs examination.

Last verified against gazette notifications: 2026-05-16. Source: BIS / DGFT / Indian Customs CUSDATA.