Of nickel alloys

Tubes and pipes of nickel alloys

NO PGA · STANDARD CUSTOMS PROCEDURE

HSN 7507 12 00 (tubes and pipes of nickel alloys) is not covered by a Bureau of Indian Standards Quality Control Order and carries no Partner Government Agency clearance requirement at the tariff-line level. Import follows the standard customs procedure: Importer-Exporter Code, bill of entry, commercial invoice, packing list. Other nickel and nickel-alloy products within Chapter 75, or pressure-service tubular goods classified elsewhere, may carry distinct compliance obligations depending on form and end-use.

No partner government agency notification covers this tariff line.

A word of counsel

The absence of compliance at this tariff line does not extend to all nickel tubular products: tube or pipe fittings of nickel alloys (couplings, elbows, sleeves) are separately classified within heading 7507 and warrant independent verification. Where customs re-examines the declared form or alloy specification and reclassifies the goods, retrospective compliance obligations and detention pending resolution follow. Confirm the precise alloy composition, product form, and intended use against the customs tariff before treating the absence of compliance as settled.

Need a regulatory steer on this product?

Speak to a regulatory counsel about your specific HSN, IS, and supplier situation.

Speak to an Expert

Frequently asked

Does HSN 7507 12 00 require any pre-import registration?

A valid Importer-Exporter Code is required for any commercial import; no product-specific registration applies to this tariff line.

What changes if the goods are nickel-alloy tube or pipe fittings rather than tubes or pipes?

Fittings such as couplings, elbows, and sleeves are classified under a separate tariff line within heading 7507 and must be independently verified for any applicable compliance requirements.

Last verified against gazette notifications: 2026-05-16. Source: BIS / DGFT / Indian Customs CUSDATA.